Air Filters Inc.™ Titan-Flo™ Aluminum Frame Foam Filter are designed for use in small equipment, electrical cabinets, small engine intake areas, electrical motor intake, HVAC equipment, and general ventilation. These filters offer low resistance, large dust holding capacity are easily cleanable with warm water and mild detergent as well as vacuuming or flushing with a reverse air flow. These filters are used dry and do not need adhesives or coatings to have great performance.
The filter media is comprised of 40 PPI polyurethane filter foam 1/8" thickness. Material is non-toxic, non-allergenic with a green coloring pleated between two layers of black epoxy coated aluminum screen. The filter shall have a retaining grid of 0.032 expanded aluminum and encased in an 0.032 thickness aluminum frame. Filter shall have a 1 piece frame with mitered corners and closed with rivets. Media must stick past screen on each side to make compression seal.
To gain top efficiency from your Air Filters Inc.™ Titan-Flo™ Aluminum Frame Foam air filter simply dust off excess dirt, flush under hot water, allow to dry and replace. A mild detergent can be used if required. However do not use oils, adhesives, house hold cleaners, industrial cleaners or alkali solutions as this will damage the filter.
AFTER CLEANING TAKE CAUTION TO ALLOW THE FILTER TO COMPLETELY DRY BEFORE RETURNING TO SERVICE. FAILURE TO DO SO WILL VOID ANY AND ALL WARRENTIES.
Customize Your Air Filter in 4 Easy Steps
Have a Question?
Send us a message below or call us at 1.800.667.8563
Ordered your filters and need to know where they are?
Want to work for Air Filters Inc.? We are hiring!
Browse a full list of industry terms to better choose your filters.