Call us today! 1 (800) 667.8563
Aire-Loc ™ Standard Housings are designed to hold two stages of filtration. Each housing shall accommodate a 2” OR 4” deep pre-filter and a bag OR rigid final filter with a 1” header. Units are offered in three housing depths, 22-1/4”, 34-1/4”, and 42”.
Housing depths are determined by the final filters that are required per applications. The housing are intended for new and replacement applications. Unites are factory assembled in a "one-piece rugged construction," and reinforced with corner gussets to add extra stability. Each unit is supplied with 1" flanges on the entering and leaving sides of housing for easy installation to the duct and air handling systems. Access doors shall be fully gasketed around the perimeter with a closed cell neoprene gasket to ensure an air tight seal when closed. A closed cell urethane foam is included on the inside of the doors and walls to seal against the filter edge to eliminate air by-pass. After fabrication units shall be sealed with a silicone compound on areas where metal meets metal, assuring a sealed housing.
Air Filters, Inc. offers optional construction on the SASH's including metal type, special flanged, insulation, weatherproofing, custom sizes, and any specified construction applications. With Air Filters, Inc Standard Air Filter Housing, there's no time consuming problems of field installation, modular sections, or add-on sections.
Send us a message below or call us at 1.800.667.8563
Ordered your filters and need to know where they are?
Want to work for Air Filters Inc.? We are hiring!
Browse a full list of industry terms to better choose your filters.